To clean gutters with a pressure washer, work from the ground with a curved telescoping wand, start at the far end of the run and flush toward the downspout, then clear the downspout separately from the bottom. Scoop the heavy debris out first — water turns packed leaves into a dam — and never stand on a ladder holding a running machine.
That last point is the reason this page exists. Gutter cleaning is the household job most worth doing from the ground, and it is also the one people most often do from a ladder while holding a machine that produces a sideways force at the nozzle. A kickback, a sudden blockage clearing, or a hose snagging is enough to move a ladder.
What you need
A curved telescoping extension wand. The Tool Daily 21-foot wand reaches a typical single-story gutter and most of a two-story one from the ground. At full extension it is genuinely heavy and the water weight makes the last few feet awkward, so expect to work in sections rather than sweeping the whole run in one go. Pressure also drops noticeably over 21 feet of extension, which is fine for flushing and the reason this is not a paint-stripping tool.
The right fitting. This is where most of these purchases go wrong. If your machine uses M22 threads rather than quick-connect, you need an adapter set before anything bolts together — the M MINGLE M22 to 1/4-inch set covers both the gun end and the wand end. Check your machine’s thread size first; M22-15mm and M22-14mm are not the same. The whole fitting question is explained in the quick-connect guide.
A modest machine. A 1,600 to 2,000 PSI electric is plenty. Flushing debris out of a channel needs water volume more than pressure, and high pressure aimed at a roof line is how people force water under shingles. The product picks are in best gutter cleaning attachments.
Eye protection. Everything that comes out of a gutter comes down, and some of it is grit.
What this method cannot do
Remove packed, wet, composted leaf matter. A gutter that has not been touched in three years contains a solid mass that water will not move. That has to come out by hand. Pressure washing is maintenance, not rescue.
Clear a blocked downspout from the top. Forcing a blockage downward compacts it at the elbow and makes the problem worse. Go in from the bottom.
Clean gutters with guards fitted. Mesh and helmet-style guards need lifting or removing first; flushing on top of them just pushes debris into the mesh.
Inspect anything. A gutter that leaks, sags or pulls away from the fascia needs eyes and hands on it, which means a ladder, with the machine off.
The black streaks are a separate job
The dark vertical staining on the outside of a gutter is not dirt and pressure does not remove it. It is a combination of oxidized material and organic growth, and it needs a cleaner with real action against mold and algae, applied and left to dwell. 30 Seconds Outdoor Cleaner acts visibly within minutes, dilutes a long way and works through a downstream injector; apply it, wait, rinse at low pressure.
Pre-wet whatever is below first. Anything you spray on a fascia lands in the beds and on the siding beneath it, and both deserve a rinse afterwards. The method is the same one used for a house wash — see house wash soaps and mix ratios.
Where the water is allowed to go
Not up under the drip edge. Aiming a jet upward at the roof line can push water under the shingles and into the roof deck, which is an expensive way to clean a gutter.
Not at a skylight, a vent or a soffit vent.
Not at the electrical service entry, the meter or any exterior fixture. This is a general rule for the whole house, and it is in pressure washer safety for beginners.
Not where the run-off has nowhere to drain. A gutter’s worth of composted debris arriving on a patio is a job in itself.
While you are up there with the wand
The same telescoping wand does the second-story siding you cannot otherwise reach, which is the other job that keeps people on ladders. Use a wide tip, work top to bottom, and remember that the pressure you feel at 21 feet is lower than at the gun — so if siding is the real goal, read how to pressure wash a house first. For anything two stories up that needs real cleaning rather than rinsing, the answer is usually soft washing, not more pressure.